Contains:  Gear
Epsilon 130D Ready to go!, JasonC

Epsilon 130D Ready to go!

Epsilon 130D Ready to go!, JasonC

Epsilon 130D Ready to go!

Description

UDPATE: Fixed my dovetail manually by drilling holes that would accomodate my Takahashi tube rings. Installed the USB hub, and mounted the focuser controller on the scope along with some much better cable management than what I have used in the past. I am almost ready to image. I have to do some polar alignment / PEMPRO work on my Mach1 and get the tracking good... then I just wait for clear skies to image. It has been cloudy for what seems like months now. My guess, September I can image again.

My new Epsilon 130D ready to go. I had some issues with mounting it as the Tak tube rings would not fit on my current dovetail. I was able to flip the tube rings around and use the top mounting plate area to mount to the dovetail to get it to work. So, works for now, but need to get a dovetail that will fit the proper side. Other than that, it's ready to go. Put it on my mount to get it balanced and take this picture of it. Just waiting for the skies to clear now.

Comments

Revisions

  • Epsilon 130D Ready to go!, JasonC
    Original
  • Epsilon 130D Ready to go!, JasonC
    B
  • Epsilon 130D Ready to go!, JasonC
    C
  • Epsilon 130D Ready to go!, JasonC
    D
  • Epsilon 130D Ready to go!, JasonC
    E
  • Epsilon 130D Ready to go!, JasonC
    F
  • Epsilon 130D Ready to go!, JasonC
    G
  • Epsilon 130D Ready to go!, JasonC
    H
  • Final
    Epsilon 130D Ready to go!, JasonC
    I

Histogram

Epsilon 130D Ready to go!, JasonC