0.00
#...
·
 |
|---|
|
Recently i bought an ioptron cem70. for several nights i used it. but last night during working and slewing some times could not slew. so i switch it off. after 1 minute I brought it to zero position manually, then i switched on, but power button could not illuminated and the hand controller turned on and just show ioptron logo. and then after few seconds this message came up: "Connection error detected in following board(s): Main Board". ioptron advised me to check power source, HC cable and sockets, etc. finally I should send HC and main-board to the ioptron office to checking and repairing. It will be free of charge except S&H if the mount is under 2 year warranty. |
0.00
#...
·
|
|---|
| Well that's a bummer... I have a CEM 70G and sometimes the Guide camera won't connect to my NINA thingy.... so I have to open up the back of the camera, unplug the USB which requires a pair of pliers and plug it back in... but other than that, my mount has been great... |
